My Wahoo!

Even as I look for fair days to eke the last out of the fishing season here in Boston, I’m looking ahead to winter. And with a boat in a slip that means two things: haul out and winterizing.

“Haul out” is the day the boat needs to be gone from its slip. The Point of Pines Yacht Club has decreed that to be this Saturday. Given the screwy and limited access to usable boat ramps around here, haul out means first driving the trailer down to the Nahant Town Wharf, then hitching a ride over to the POPYC six miles away by car, and finally running the boat three miles across Broad Sound to the trailer. The many rocks and shoals between Point of Pines and Nahant make that journey a lot safer to undertake when the tide is high. Unfortunately this Saturday high tide is at 6 a.m. 🙁

Winterizing of course is the process of getting the boat ready for winter storage; basically six months of sitting. The goals of winterizing are pretty simple but worth listing out:

• Protect the boat, trailer, and engine from rust and corrosion
• Protect the boat from incursions of water, that can cause mold, mildew, rust, and freeze and expand causing breakage
• Ensure the fuel system is protected from moisture and breakdown of the fuel (which can gum up the lines and engine)
• Protect the boat from leaves, animals, birds, and other things that can damage or dirty it
• Remove any marine growth from the hull before it hardens
• Ensure the boat is fully serviced and ready to go in the spring Continue Reading…

It rained the other night in Boston. Or said another way…it RAINED the other night in Boston. Six inches in two hours! At times the rain was so loud it sounded like a freight train. I lay in bed listening and smiling, thinking of my Wahoo! in its slip, warmed by the thought of the two bilge pumps I’d installed this past year (one in the deck drain basin and one in the true bilge), doing their job. No worries.

Until I remembered that the day before I’d taken the battery out of the boat and brought it home to charge it. Shoot.

It being a weekday, I had to go to work that morning and couldn’t check on the boat until later. All day I wondered if I’d find it full of water up to the gunnels or worse. It wasn’t though. I walked out onto the dock that evening to find it bobbing in its slip. Well not bobbing, exactly. Actually the stern was sitting pretty low in the water. I hooked up the battery and the pumps went to work, removing about 100 gallons of water, most of it from below deck.

Once the season is over and I have more time I’ll write a lot more about the Wahoo!s plumbing…the supposedly self-bailing system, the deck drain, the true bilge, what drains into where and so on. It’s one of the most confusing aspects of these boats and one of the most asked about by Wahoo! owners. For now, though, I’ll just say that in my (limited) experience: A) If you keep your Wahoo! in the water you most definitely need a bilge pump, and quite likely two; B) Even if you don’t keep it in the water you may prefer a pump in the deck drain basin to Wahoo!s self-bailing design; and C) Rule pumps…ummm….rule. They are rugged, dependable workhorses. And made right here in the great state of Massachusetts. 🙂